Remove both the front and rear trigger plate screws. With the safety off, the triggers should spring rearward and allow you to unscrew the trigger guard from the frame. Nothing could look worse on a fine double-barreled shotgun than screws that have been damaged by screwdrivers that do not fit. I cannot stress enough the importance of using good screw drivers. Using either the long screw or a 1/8-inch punch inserted from the right and through the frame, push the left lock assembly away from the frame. Using the long screw as a handle, install it in the outside of the right sideplate and pull gently until the rear of the plate swings away from the frame. With a well fitted, parallel ground screw driver, remove all of the sidelock screws. If this is the case, the plate assemblies will have to be rebedded. If it is not, this is a sign that the stock of the shotgun has shrunk and that the sideplates may be drawn too closely together by the torque of the rear screw. The threaded end should be relatively flush with the outside of the right plate. The regular framed shotguns use only the longer screw.Įxamine the longer screw before removing it. The featherweight models have their lock assemblies attached by three screws, one in the front of each sideplate (attaching the plates to the frame) and a longer screw installed from the left plate (attaching the sidelocks to each other).

Smith will be much easier to remove if the hammers are tucked out of the way as they are when cocked. Normally, gunsmiths want to be sure that a firearm‘s action is not cocked prior to disassembly, but the sidelocks of an L.C. To begin disassembly, open the shotgun to ensure that it is unloaded and that it is cocked. Smith hammerless shotgun is its disassembly, cleaning, oiling and reassembly. Its rotary bolt and extremely strong top lever spring make it a seemingly difficult shotgun to disassemble and put back together, so a good place to start any instruction on the L.C. Smith is one of the most requested services on this shotgun. This is why cleaning and properly oiling the L.C. Smith shotgun is very sensitive to dirt and foreign matter within its action.

If you own a Smith and want to make it suitable to shoot again, or if you are presented a Smith to repair, here’s what you need to know about the shotgun. Smith’s side-lock design have made it a very desirable shotgun for both the sportsman and collector alike, and with the recent conditional approval of bismuth shot, which eases many Smith owners’ worries about steel shot, many of these fine old shotguns will be brought back into service as waterfowl shotguns. The graceful beauty and light construction of the L. Smiths were manufactured by the Hunter Arms Company. Smith Gun Company, but in 1888, the company was bought by John Hunter, Sr., and was moved to Fulton, New York. Smith Hammerless Double was first produced in Syracuse, New York, in 1886 by the L.

Buckshot in old shotgun lc smith